# Blacklist

EMQX Broker provides users with a blacklist function. Users can add specified clients to the blacklist through the relevant HTTP API to deny access of the client. In addition to the client identifier, it also supports direct ban of user names and even IP addresses.

For specific usage of the HTTP API, see HTTP API - blacklist for reference.


The blacklist is only applicable to a small number of client bans. If there are a large number of clients requiring authentication management, please use the authentication function.。

Based on the blacklist function, EMQX Broker supports automatic banning of clients that are frequently logged in for a short period of time, and rejects these clients for a period of time to prevent such clients from occupying server resources so that the normal use of other clients is affected.

It should be noted that the automatic ban function only bans the client identifier, not the user name and IP address. That is to say, the machine can continue to log in as long as the client identifier is changed.

This function is disabled by default, and users can set the enable_flapping_detect configuration item to on in the emqx.conf configuration file to enable this function.

zone.external.enable_flapping_detect = off

The user can adjust the trigger threshold and the ban time for this function. The corresponding configuration items are as follows:

flapping_detect_policy = 30, 1m, 5m

The value of this configuration item is separated by ,, which in turn indicate the number of times that the client is offline, the detection time range, and the ban time. Therefore, the above default configuration means that if the client goes offline 30 times in 1 minute, the client's 'identifier will be banned for 5 minutes. Of course, you can also use other time units such as seconds and hours. For this part, please refer to Configuration Instructions.

What’s on this page