Add Existing Edge Services ​

ECP provides the capability to manage existing edge services. However, these services must first be added to ECP. You can add them either one by one or, if adding Neuron or eKuiper edge services, you can do so in bulk.

Add an Existing Edge Service ​

ECP supports the addition of a Neuron or eKuiper in both direct connection and proxy modes.

Direct Connection Mode ​

Direct connection mode generally refers to the scenario where the cluster and all edge services are within the same local area network and can access each other.

1. Log in as system admin, organization admin, or project admin.
2. Click the Add Edge Service button to enter the Add Edge Service page.
3. Choose Add existing service for Add Type.
4. For Category, you can choose eKuiper, Neuron, NanoMQ, or Customize.
5. Choose Direct Connection for the Connection Type;
6. Give a name to the edge service; it should be 1 - 200 characters, and also support "-" and blank spaces.
7. Enter the access address of the edge service. HTTP and HTTPS protocols are supported;
8. Add tags to facilitate future management. For details, see Tags.
9. Click the Confirm button to finish the creation. The newly-added edge service is now displayed in the Edge Service section.

Proxy Mode ​

If the edge side and ECP are on separate networks and cannot establish a direct connection, it is necessary to install ECP Agent to establish a proxy connection.

Operation Steps ​

1. Log in as system admin, organization admin, or project admin.
2. Click the Add Edge Service button to enter the Add Edge Service page.
3. Choose Add existing service for the Add Type.
4. For Category, you can choose eKuiper, Neuron, NanoMQ, or Customize.
5. Choose Proxy for the Connection Type;
6. Give a name to the edge service; it should be 1 - 200 characters and also support "-" and blank spaces.
7. Enter the access address of the edge service. HTTP and HTTPS protocols are supported;
8. Add tags to facilitate future management.
9. Click the Confirm button to finish the creation. The newly-added edge service is now displayed in the Edge Service section.

Add Existing Edge Services in Bulk ​

ECP supports batch importing of existing edge services in CSV file format.

• Log in as system admin, organization admin, or project admin.
• Click the Add Edge Service button to enter the Add Edge Service page.
• Choose Import existing services in batches for the Add Type.
• Import the prepared .csv file. Note: The file size should be less than 100 MB.

After the import, the imported edge services will automatically be displayed in the Edge Service panel. Note that only data in a valid format will be imported, and the system will flag any incorrectly formatted entries.

The following table provides an overview of the column names of the .csv file and their corresponding explanations: